You might find the following setups useful with parts: \definestructureresetset [default] [0,0] [1] % do not reset parts and chapters \setuphead [part] [sectionresetset=default, conversion=Romannumerals, placehead=yes, bodypartlabel=part] Also, using parts, you might also need to add "part" to the table of contents list. etc. Alan On Sun, 30 Aug 2015 12:46:50 +0200 Otared Kavian wrote:

Hi Eric,

If you use either \part{This is part 1}

or

\startpart[title={This part 2}] \startchapter[title={This is chapter 1}] \stopchapter \stoppart

you get a title for part 1 and part 2.

Best regards: OK

...

On 30 Aug 2015, at 11:42, Eric Détrez wrote:

"By default \part generates no title because most of the times these require special attention and a specific design."

I can't find how to write such a specific design.

-- Eric Détrez Informatique Lycée Faidherbe, Lille http://eric-detrez.fr

-- Alan Braslau CEA DSM-IRAMIS-SPEC CNRS UMR 3680 Orme des Merisiers 91191 Gif-sur-Yvette cedex FRANCE tel: +33 1 69 08 73 15 fax: +33 1 69 08 87 86 mailto:alan.braslau@cea.fr