![](https://secure.gravatar.com/avatar/48c5b7faef52e59adf59c5e8f764aaf7.jpg?s=120&d=mm&r=g)
I am trying to process a document I wrote in 2009 using mkii. I am modifying it to work with mkiv. When I run context mydoc.tex the process starts and after some time it stops and shows an asterisk (*) waiting for a command. I then type in "\end", and it resumes. Finally it ouputs "mydoc.pdf". There are still some things to fix (ie section numbers) but in general the document is ok. I can't see any "error" message although I got a lot of "Overfull \hbox..." and "Underfull \hbox..." messages. What can be the reason?
![](https://secure.gravatar.com/avatar/386a116d129cdc597f2bb6210bbaff7a.jpg?s=120&d=mm&r=g)
On Sun, Jun 3, 2012 at 9:39 AM, Alfredo Catalina
I am trying to process a document I wrote in 2009 using mkii. I am modifying it to work with mkiv.
When I run
context mydoc.tex
the process starts and after some time it stops and shows an asterisk (*) waiting for a command. I then type in "\end", and it resumes. Finally it ouputs "mydoc.pdf". There are still some things to fix (ie section numbers) but in general the document is ok.
I can't see any "error" message although I got a lot of "Overfull \hbox..." and "Underfull \hbox..." messages.
What can be the reason? Something like a missed \stoptext , i.e. \starttext .. .. %\stoptext
A good strategy is to move \stoptext from bottom to up next to \starttext until a correct compilation. -- luigi
participants (2)
-
Alfredo Catalina
-
luigi scarso