Hi, can I expect a fix for this problem in the next time or will this take longer. Wolfgang Am 26.11.2008 um 11:57 schrieb Wolfgang Schuster:

in MkIV there is a problem when I set tints for a color.

This is a complete minimal example of my setup:

\setupcolors[state=start,rgb=no,cmyk=yes,spot=yes] % rgb= no needed in MkII

\setupcolor [hex]

\definecolor[PantoneOneEightSeven][h=C40F2F,e=Pantone 187 U]

\definespotcolor[dtkred] [PantoneOneEightSeven][p=1.0] \definespotcolor[dtkredlight][PantoneOneEightSeven][p=0.7]

\starttext

\blackrule[width=4cm,height=4cm,color=dtkred,]

\blackrule[width=4cm,height=4cm,color=dtkredlight]

\stoptext

I could also reproduce it with a short setup:

\setupcolors[state=start,rgb=no] % rgb= no needed in MkII

\definespotcolor[dtkred] [red][p=1.0] \definespotcolor[dtkredlight][red][p=0.7]

\starttext

\blackrule[width=4cm,height=4cm,color=dtkred,]

\blackrule[width=4cm,height=4cm,color=dtkredlight]

\stoptext

With the setting rgb=yes the color dtkred is correct in the output but dtkredlight is darker than dtkred, with the setting rgb=no dtkred is black in my document.

Wolfgang