On 8/5/2015 3:05 AM, talazem@fastmail.fm wrote:

Dear all,

What is the replacement for `localenvironment` in project structures?

The first part of my book has one layout; the second has another. I have designed one environment for the first part, and another environment for the second. I do not want the first environment to be used for the second half of the book.

In cont-eni.pdf, I read about using `localenvironment` for such scenarios, but it seems this has been removed.

This is probably a very basic question, but how do I should change the following such that *one pdf* is produced, where the first part—ComponentA—uses EnvironmentA’s layout, while the second part—ComponentB—uses EnvironmentB's. If any startsetups need to be defined, I’d be grateful for any example, showing also where to place them.

# Product \startproduct MyProduct \component ComponentA \component ComponentB \stopproduct

# EnvironmentA \startenvironment envA % the definitions \stopenvironment

# EnvironmentB \startenvironment envB % the definitions \stopenvironment

# ComponentA \environment envA \product MyProduct \startcomponent ComponentA \starttext … \stoptext

# ComponentB \environment envB \product MyProduct \startcomponent ComponentA \starttext … \stoptext

(1) set up a common style and then load specific ones for each part or (2) use grouping \start \component #1 \stop although this assumes that settings are not global -- ----------------------------------------------------------------- Hans Hagen | PRAGMA ADE Ridderstraat 27 | 8061 GH Hasselt | The Netherlands tel: 038 477 53 69 | voip: 087 875 68 74 | www.pragma-ade.com | www.pragma-pod.nl -----------------------------------------------------------------