Hello everyone, an issue arised while writing a letter with the third party module t-letter (http://modules.contextgarden.net/letter). I've read the official documentation (Correspondence with ConTeXt) but I found no solution to: a) Setup a header/footer for the first page and configure a different one for the following pages. Page 46 of the documentation describes the setup of the specific (letter) layers. With the "state" parameter it's possible to enable (= "start"), disable (= "stop") the header or start it on the second page and the following (= "next"), but if I configure the header for the first page with \setupletterstyle[head] [ state=start, alternative=left, fromrule=top, ] and then for the following pages \setupletterstyle[head] [ state=next, ... ] only the second setup is typeset. From this it follows that the first setup is just overwritten. The header on the first page should only contain a name and than a thin line (a "\hairline" similar to the built-in variable "fromrule"). The header on the following pages should contain variable things and than also a thin line. Unfortunately I found no possibility to get this done. b) I would like to define a back address which should be typeset above the addressee. Page 44 of the documentation illustrates amongst other layers the back address layer, but there is no way to activate and configure this layer. I've tried it with \setupletter[backaddress][...] and \setuplayer[backaddress][...]. Maybe someone have a tip. Thank you and have a nice week. Benedikt ps: A small (commented) letter template is attached below (as tex file).