ishamid wrote:
Hi
===== Original Message From mailing list for ConTeXt users
Then I tried the steps Idris recommend once:
eomega --ini *plain \dump eomega --ini *cont-en texexec --make en -tex=eomega
are the relevant commands. eomega _is_ aleph.
I'm sure of course that you replaced `eomega' with `aleph';-)
There should be no need to add aleph.exe to your path if you just refresh the fndb, which I'm sure u did also;-)) (I don't know about MacOSX but TeXLive contains a shortcut to that command in Programs=>TeXLive=>Maintanence).
I (or Hans) will send you the stuff Hans sent me if all else fails: that will work for sure.
the latest release contains a texexec: texexec --make --all --alone --tex=aleph you can configure texexec.ini to use the engine subpath which is handy when you run pdfetex along side (the new binaries all have the same suffix now; tetex will not support the tds engine subpath, i dunny yet about fptex and miktex; let's hope that they do) (--engine is also possible in texexec 5.0) Hans ----------------------------------------------------------------- Hans Hagen | PRAGMA ADE Ridderstraat 27 | 8061 GH Hasselt | The Netherlands tel: 038 477 53 69 | fax: 038 477 53 74 | www.pragma-ade.com | www.pragma-pod.nl -----------------------------------------------------------------