Re: [NTG-context] Can you make a \setupTABLE only apply to one table?

Thanks for the help! On Sat, Dec 5, 2020 at 10:21 PM Jairo A. del Rio wrote:

Hi, You could enclose your table and setup using \bgroup and \egroup

\bgroup \setupTABLE ... \bTABLE ... \eTABLE \egroup

\begingroup ... \endgroup also works, although I have to admit I'm not aware of the differences between both.

Regards,

Jairo :)

El sáb., 5 de dic. de 2020 10:01 p. m., T. Kurt Bond escribió:

...

If I understand correctly, \setupTABLE applies to each table after the \setupTABLE, correct? If so, can you make it only apply to one table?

-- T. Kurt Bond, tkurtbond@gmail.com, https://tkurtbond.github.io

___________________________________________________________________________________ If your question is of interest to others as well, please add an entry to the Wiki!

maillist : ntg-context@ntg.nl / http://www.ntg.nl/mailman/listinfo/ntg-context webpage : http://www.pragma-ade.nl / http://context.aanhet.net archive : https://bitbucket.org/phg/context-mirror/commits/ wiki : http://contextgarden.net

___________________________________________________________________________________

___________________________________________________________________________________ If your question is of interest to others as well, please add an entry to the Wiki!

maillist : ntg-context@ntg.nl / http://www.ntg.nl/mailman/listinfo/ntg-context webpage : http://www.pragma-ade.nl / http://context.aanhet.net archive : https://bitbucket.org/phg/context-mirror/commits/ wiki : http://contextgarden.net

___________________________________________________________________________________

-- T. Kurt Bond, tkurtbond@gmail.com, https://tkurtbond.github.io