I am using: mtx-context | current version: 2014.10.18 14:30 I am typesetting a simple letterhead for correspondence. The design calls for only about a 3 to 5 mm distance between the physical top of the page and the top of the typeset letterhead. The pdf view of the output looks good, but an actual printout (and a look at a "print preview" with a pdf viewer) of the generated pdf file puts the top of the letterhead about 17 mm (14mm over target size) down from the top edge. This is too much. I tried adjusting topspace and topdistance to 0 didn't seem to have any affect. In \setlayer I set y=3mm I tried adjusting topspace but it didn't do what I wanted and topdistance was already 0. I am using theh ConText standalone: mtx-context version: 2014.10.18 14:30 Here is a simple minimal file. % % Start of minimal example \setuppapersize[letter][letter] \setuppagenumbering[location=footer] \setuplayout[ backspace=31mm, header=5mm, rightmargin=2cm, leftmargin=2cm ] \definelayer [Logo] % name of the layer we are defining [ repeat=yes, x=5mm,y=3mm, % Just what is this? hoffset=0mm,voffset=0mm, % and what is this? ...offset from where? width=\paperwidth ] \setupTABLE[r][1,2,3][height=5mm,frame=off] % Put letterhead information in here. \starttext \setlayer[Logo][] { \bTABLE \bTR \bTD \eTD \bTD \sc{Company Name}\eTD \bTD \sc{info}@\sc{something}.\sc{where} \eTD \eTR \bTR \bTD \eTD \bTD 2059 Forest Ave, Ste X \eTD \bTD \sc{www}.\sc{domain}.\sc{topleveldomain} \eTD \eTR \bTR \bTD \eTD \bTD City, Province \eTD \bTD Tel (xxx) 999-1234 \eTD \eTR \eTABLE } \setupbackgrounds[page][background=Logo] ~ % Need `` to avoid a NULL content page so can generate a pdf \stoptext % % End of minimal example Regards