Dear all, I have a small but nasty problem with the book I’m (still) working on. Its 10 chapters contain many Blockquotes, and they all come out as intended except one, in the first, unnumbered, chapter “Introduction". That particular blockquote v]comes out like the others only as far as its width and its fontsize are concerned, but unlike the others it insists on keeping the same interline distance as the main text. Even that would not have been too much of a problem if it had not spoiled the layout by pushing a rather large float off the page, leaving a large gap. This particular chapter is input by means of the Frontmatter file, as is Ch1, which also contains several Blockquotes, that come out OK. When I process this chapter “Introduction" separately with the same setups the blockquote also comes out allright. When, as a test, I input that chapter again, the second time through the Bodymatter, then again it comes out allright (while the blockquote in the real Ch0 keeps its large interline distance). I have tried the following: - add the setup for the blockquote to the Frontmatter file - add the setup for the blockquote also to the Ch0 file itself - add \setupinterlinespace[small] in the text just before the blockquote and \setupinterlinespace[reset] after it. None of this has changed the interline distance of the blockquote one bit. Is there anybody on this list for whom this problem is or sounds familiar and who knows a remedy? If not, which information would I have to give to make a diagnosis possible? (It may be evident that it is impossible to show the problem in an MWE.) Thanks in advance for any help. Best regards, Robert Blackstone