Re: [NTG-context] Include section number in reference

15 Oct 2011

      Am 14.10.2011 um 13:28 schrieb Wolfgang Schuster:
...
Am 14.10.2011 um 13:18 schrieb Marco:
...
On 2011-10-13 Wolfgang Schuster  wrote:
...
\setupreferencestructureprefix[default][prefixsegments=2:*]
Thanks.
Wikified. (Although without explanations, just an example)
I can also provide the entry from my command reference (no yet in the PDF):
\setupreferencestructureprefix[.1.][.2.][..,.3.,..]
                            optional
1. IDENTIFIER (float, formula, figure, SECTION (e.g. section, subsection, …), …)
2. number, page, title, text or default
3. prefix              = yes (default), no
  prefixseparatorset  = IDENTIFIER
  prefixconversionset = IDENTIFIER
  prefixset           = IDENTIFIER
  prefixsegments      = SEGMENTS
  prefixconnector     = TEXT
Below I describe the values of the three arguments.

The first (and optional) argument can be used to specify the element,
where you want to customize the reference. When you use “float” the setting
affects all kind of floats which are created with \definefloat but you
also change only certain float type when you use the name of the float,
e.g. figure or table. When you want to change the layout for a heading you
need the name of it, e.g. chapter or section (not sure about this because
I haven’t checked this).

The second argument specifies the reference type, you can the values
of these types in the following example. When you refer to a section
or float with \in context uses the “default” type and when you use
\at it uses the “page” type.

\startsetups[reference:table]

	\starttabulate
	\NC \bf key  \EQ \bf value                 \NC\NR
	\NC number   \EQ \currentreferencenumber   \NC\NR
	\NC page     \EQ \currentreferencepage     \NC\NR
	\NC title    \EQ \currentreferencetitle    \NC\NR
	\NC text     \EQ\currentreferencetext      \NC\NR
	\NC default  \EQ \currentreferencedefault  \NC\NR
	\NC realpage \EQ \currentreferencerealpage \NC\NR
	\stoptabulate

\stopsetups

\definereferenceformat[referencetable][setups=reference:table]

\starttext

\section[sec:table]{Values for the reference command}

\starttyping
\startsection[reference=sec:table,title={Values for the reference command}]
\stoptyping

\referencetable[sec:table]

\startbuffer
\reference[ref:test]{Is this the text or the title?}
\stopbuffer

\getbuffer \typebuffer

\referencetable[ref:test]

\stoptext

With the third argument you can control which prefixes (section numbers
which are shown in front of a floats own counter value) are shown and
how they should be formatted.

Wolfgang